the time has come! for the life-size printing š i’m getting a good hang of splitting the pieces and printĀ ready with minĀ overhang issue with max printable area .
also i’ve noticed the crack on Rocket’s print where surface was so thin after 2 yrs. i skimmed on infill pass because I did’t quite understand even a little amount of support inside makes difference in surface strength and impact on printing time and material is negligible.
Ultimaker 2 (face):
| layer height | 0.2mm |
| shell thickness | 0.8mm |
| fill density | 10% |
| print speed | 50mm/s |
| bot/topĀ thickness | 0.6mm |
| nozzle size | 0.4mm |
Ultimaker 2+ Extended (hair) :
| layer height | 0.2mm |
| shell thickness | 0.8mm |
| fill density | 5% |
| print speed | 20mm/s |
| bot/topĀ thickness | 0.4mm |
| nozzle size | 0.8mm |
