hot-dry days are best days to 3D print… the room temperature was constant and no moisture in the air (PLA thanks you)
A piece in progress: I’ve read about ColorFabb PLA print result differences depends on the batch (true? dunno…). I used to print with 200C but it seemed like it was under extruding or previous Cura setting I used to print a same model wasn’t working well by creating blotchy infill walls. Set the temp to 210C and infill was building normally (didn’t re-adjust a print speed). However the print came out pretty and the updated Cura’s printing estimate time is very accurate now that I can plan my life around it.
